Here's how to properly mount the Verizon Receiver (LV65) receiver on an exterior wall.
- While outdoor self-setup is possible for customers with advanced home maintenance skills, we recommend most customers schedule an appointment for professional outdoor setup.
- Outdoor self-setup is an advanced installation and should only be attempted by customers who are experienced in mounting to the exterior of their homes. Failure to properly mount the Receiver may result in damage to the equipment or your home.
- Don't attempt this installation if the siding material or backing material type is unknown.
- If you are uncomfortable with any part of this setup process, contact us.
- Verizon is not responsible for damage to property caused by the installation process.
Mounting for the Verizon Receiver (LV65) is performed within the My Verizon app for Google™ Android™ and Apple® iOS.
- Position the outdoor bracket against the wall just above the sticker and make sure the arrow is pointing up. TapContinue.Watch this video for a demo.
- If your wall has siding, place one or both siding wedges behind the bracket then tapContinue.Watch this video for a demo.
- Mark the wall through the bracket slots that have screw icons then tapContinue.Watch this video for a demo.
- Use a 1/4-inch drill bit to drill a hole about 2 inches deep then tapContinue.Wear protection for your eyes, hands and face. Avoid drilling into electrical wires, gas lines, and water pipes, which can lead to injury or property damage.Watch this video for a demo.
- Insert the anchors into the holes gently tapping them in with a hammer then cover with exterior sealant. TapContinue.Improper drilling and sealing may lead to damages including water and/or bug intrusion.Watch this video for a demo.
- Align the bracket to the holes in the wall. Position the screws through the bracket and siding wedges, if applicable, then drive the screws into the anchors. Don’t over tighten. TapContinue.Watch this video for a demo.
- Remove the Receiver’s cover. Use the open notch by the cable to push the Receiver until the cover unlocks then tapContinue.Watch this video for a demo.
- Attach the Receiver to the bracket. Hold the Receiver so the words 'Verizon Receiver' are facing you. Align the slots on the Receiver to the bracket clips and click the Receiver into place then tapContinue.Watch this video for a demo.
- Insert the bracket shims into the slots on the sides of the Receiver. The bracket shims should easily fit into place. TapContinue.Watch this video for a demo.
- Place the cover back on the Receiver. Lightly push the cover upward to engage the cover lock then tapContinue.Watch this video for a demo.
- Confirm 5G signal and internet are enabled then tapContinueto finish the setup.This may take up to 2 minutes.If prompted, log in to My Verizon.
