Samsung 4G LTE Network Extender 2 - Install the GPS Extension Cable

Here's how to install the GPS extension cable on your Network Extender 2.

If a stable GPS signal isn't detected, follow the steps below to install the GPS antenna cable.

A minimum of 4 satellites are required to provide a GPS location fix. The number of available satellites is shown on the LCD display during setup, or you can access the Network Extender admin page to verify GPS status.

For best results, place the Network Extender in an elevated location near a south-facing window or a window with a clear view of the sky.

Ensure the Network Extender is powered off by disconnecting the power adapter from the outlet.

From the top edge, press

open

then remove the GPS antenna cover.

Press down then detach the GPS Antenna.

Remove the GPS antenna then connect it to the appropriate end of the GPS antenna cable (mini-coax).

Connect the GPS antenna cable to the GPS antenna cable connector.

Don't force the cable into the mini-coax connector as this may damage it.

Replace the GPS antenna cover while the cable is threaded through the opening.

GPS antenna opening with cable threaded through

Place the GPS antenna in an elevated location then plug the Network Extender back into a wall outlet and allow the device to go through the setup process again.

For best results, place the GPS antenna near a south-facing window or a window with a clear view of the sky, and with the 'GPS' letters facing up.

If sufficient GPS signal still can't be acquired, test your Network Extender at a different location.

Initial Connection Activation and Setup

How to Set Up Your 4G LTE Network Extender

Layer_4 Created with Sketch.

Samsung 4G LTE Network Extender 2 - Install the GPS Extension Cable